PCL Emul menu
Menu item Description
Font Source
Resident
Disk
Flash
Download
All
Specifies the set of fonts used by the Font Name menu item
Notes:
• Resident is the factory default setting. It shows the factory default set
of fonts downloaded into RAM.
• Flash and Disk settings show all fonts resident in that option.
• Flash option must be properly formatted and cannot be Read/Write,
Write, or password protected.
• Download shows all the fonts downloaded into RAM.
• All shows all fonts available to any option.
Font Name
RO Courier
Identifies a specific font and the option where it is stored
Notes:
• RO Courier is the factory default setting.
• RO Courier shows the font name, font ID, and storage location in the
printer. The font source abbreviation is R for Resident, F for Flash, K
for Disk, and D for download.
Symbol Set
10U PC-8
12U PC-850
Specifies the symbol set for each font name
Notes:
• 10U PC-8 is the US factory default setting.
• 12U PC-850 is the international factory default setting.
• A symbol set is a set of alphabetic and numeric characters,
punctuation, and special symbols. Symbol sets support the different
languages or specific programs such as math symbols for scientific
text. Only the supported symbol sets are shown.
PCL Emulation Settings
Point Size
1.00–1008.00
Changes the point size for scalable typographic fonts
Notes:
• 12 is the factory default setting.
• Point Size refers to the height of the characters in the font. One point
equals approximately 1/72 of an inch.
• Point sizes can be increased or decreased in 0.25-point increments.
PCL Emulation Settings
Pitch
0.08–100
Specifies the font pitch for scalable monospaced fonts
Notes:
• 10 is the factory default setting.
• Pitch refers to the number of fixed-space characters per inch (cpi).
• Pitch can be increased or decreased in 0.01-cpi increments.
• For nonscalable monospaced fonts, the pitch appears on the display
but cannot be changed.
170
To Next Page
Loading...
Need help?
General
