Menu item Description
Job Buffering
On
Off
Auto
Temporarily stores jobs on the printer hard disk before printing
Notes:
• Off is the factory default setting.
• The On setting buffers jobs on the printer hard disk.
• The Auto setting buffers print jobs only if the printer is busy processing data
from another input port.
• Changing this setting from the control panel and then exiting the menus
causes the printer to restart. The menu selection is updated.
Mac Binary PS
On
Off
Auto
Sets the printer to process Macintosh binary PostScript print jobs
Notes:
• Auto is the factory default setting.
• The Off setting filters print jobs using the standard protocol.
• The On setting processes raw binary PostScript print jobs.
NetWare menu
Menu item Description
Login Name
<none>
Specifies the assigned NetWare login name
Print Mode
PSERVER
RPRINTER
Shows the assigned NetWare print mode
Network Number
<none>
Specifies the assigned NetWare network number
Activate
On
Off
Activates or deactivates NetWare support
Note: On is the factory default setting.
Ethernet 802.2
On
Off
Enables the Ethernet 802.2 frame type setting
Note: On is the factory default setting.
Ethernet 802.3
On
Off
Enables the Ethernet 802.3 frame type setting
Note: On is the factory default setting.
Ethernet Type II
On
Off
Enables the Ethernet Type II frame type setting
Note: On is the factory default setting.
Ethernet SNAP
On
Off
Enables the Ethernet Snap frame type setting
Note: On is the factory default setting.
187
To Next Page
Loading...
Need help?
General
