Menu item Description
NPA Mode
Off
Auto
Sets the printer to perform the special processing required for bidirectional
communication following the conventions defined by the NPA protocol
Notes:
• Auto is the factory default setting.
• Changing this setting from the control panel and then exiting the menus
causes the printer to restart. The menu selection is updated.
Network Buffer
Auto
3k to <maximum size allowed>
Sets the size of the network input buffer
Notes:
• Auto is the factory default setting.
• The value can be changed in 1k increments.
• The maximum size allowed depends on the amount of memory in the
printer, the size of the other link buffers, and whether Resource Save is
set to On or Off.
• To increase the maximum size range for the Network Buffer, disable or
reduce the size of the parallel, serial, and USB buffers.
• Changing this setting from the control panel and then exiting the menus
causes the printer to restart. The menu selection is updated.
Job Buffering
On
Off
Auto
Temporarily stores jobs on the printer hard disk before printing
Notes:
• Off is the factory default setting.
• The On value buffers jobs on the printer hard disk. This menu selection
appears only when a formatted disk is installed and is not defective.
• The Auto setting buffers print jobs only if the printer is busy processing
data from another input port.
• Changing this setting from the control panel and then exiting the menus
causes the printer to restart. The menu selection is updated.
Mac Binary PS
On
Off
Auto
Sets the printer to process Macintosh binary PostScript print jobs
Notes:
• Auto is the factory default setting.
• The Off setting filters print jobs using the standard protocol.
• The On setting processes raw binary PostScript print jobs.
185
To Next Page
Loading...
Need help?
General
