3-12 Service Manual
5022-xxx
CACHE Test
The CACHE Test is used to verify the processor CACHE is functioning properly.
1. Select CACHE Test from HARDWARE TESTS in DIAGNOSTICS.
The machine initiates a POR of the printer, and the following screen is displayed:
Upon completion of the POR, the following screen is displayed:
P:###### represents the number of times the CACHE test has passed, finished successfully.
Initially, 000000 is displayed. The maximum pass count is 999,999.
F:###### represents the number of times the CACHE test has failed, finished with errors.
Initially, 000000 is displayed. The maximum fall count is 999,999.
2. To exit the test, turn the printer off.
Duplex Tests
Quick Test (duplex)
This test prints a duplex version of the Quick Test that can be used to verify the correct placement of the top
margin on the back side of a duplex page. You can run one duplexed page (Single), or continue printing
duplexed pages (Continuous) until Stop ( ) is pressed. For information about changing the margin, see “Top
Margin (duplex)” on page 3-14.
Note: Before you set the duplex top margin, be sure to set the registration. See “Registration” on page 3-4.
Resetting the
Printer
CACHE Test x100
P:###### F:######
To Next Page
Loading...
