4-20 Service Manual
5022-xxx
Left cover removal
See “Left cover” on page 7-3 for the part number.
1. Place the printer on the table with the left side edge hanging over slightly.
2. Remove the waste toner assembly. See “Waste toner assembly removal” on page 4-93.
3. Open the top access door.
4. Open the front access door.
5. Remove the three screws (A).
6. Press the locking tab (B), slide the cover down, and lift the bottom out to remove the cover.
Warning: Be careful not to damage the two small locking tabs (C).
A
C
B
To Next Page
Loading...
