4-16 Service Manual
5022-xxx
Front access door cover assembly removal
See Front access door cover assembly for the part number for the models you need on page 7-3.
1. Remove the paper tray.
2. Remove the right cover. See “Right cover removal” on page 4-26.
3. Disconnect the transfer belt cable (A).
4. Press the two tabs (B) on either side of the transfer belt assembly, and lift out the transfer belt assembly.
Note: Leave the photoconductor units on the transport belt when removing.
Warning: To avoid damaging the photoconductor drum, hold the photoconductor units by their handle and
place the photoconductor units on a clean surface. Never expose the photoconductor units to light for a
prolonged period of time. See “Handing the photoconductor unit” on page 4-2 for additional
information.
AB AB
Model C52x Model C53x
To Next Page
Loading...
