Lexmark C522 - Multipurpose Feeder (MPF) Swing Arm Assembly Removal-Models C52 X Only

Repair information 4-67
5022-xxx
Multipurpose feeder (MPF) swing arm assembly removal—models C52x only
See “MPF swing arm assembly, C52x” on page 7-5 for the part number.
1. Open the top access door.
2. Open the front access door.
3. Remove the three mounting screws (A).
4. Remove the swing arm assembly from the frame.
Installation note: Refer to the following illustration if the swing arm crank comes loose from the swing arm
assembly. Make sure the end of the spring (B) is under the retaining tab (C) on the swing arm crank after
installation.
Note: Spring end (B) is shown disengaged from swing arm crank.
A