2-32 Service Manual
5022-xxx
140.xx—Autocomp (tray 1) motor error service check
Step Questions / actions Yes No
1 Turn the printer off, and remove the rear cover.
Check the connector JTRAY2 for proper
connection to the system card, the cable for
pinch points, and the cable or connector for
any other damage. See “Connectors” on
page 5-11 for the location of connectors.
Is the cable damaged?
Replace the paper pick
mechanism. See “Paper
pick mechanism assembly
removal” on page 4-68.
Go to step 2.
2
Measure the resistance across fuse F2 on the
system card.
Is the fuse blown?
Replace the system card.
See “System card
removal” on page 4-79.
Go to step 3.
3
Replace the paper pick mechanism. See
“Paper pick mechanism assembly removal”
on page 4-68.
Does the error clear?
Problem solved. Replace the system card.
See “System card
removal” on page 4-79.
To Next Page
Loading...
