Repair information 4-59
5022-xxx
Front door assembly front cable removal
See the part number for the Front door parts packet for the model you need on page 7-5.
Removal procedures are for either the left or the right front door assembly restraint cables.
Right restraint cable
1. Remove the front access cover assembly. See “Front access door cover assembly removal” on
page 4-16.
2. Release the cable spring (A) from the front door assembly.
3. Remove the gearbox/switch shield (B). See “Gearbox shield removal” on page 4-19.
4. Remove the end of the cable (C) from the frame.
Left restraint cable
1.
Remove the front access cover assembly. See “Front access door cover assembly removal” on
page 4-16.
2. Close the top access door.
3. Release the cable spring (D) from the front door assembly.
Note: In order to access the springs, make sure the top access cover is closed.
4. Remove the end of the cable (E) from the frame.
Installation note: The shortest cable installs on the right side of the printer.
To Next Page
Loading...
