Lexmark C522 - Page 97

Diagnostic aids 3-3
5022-xxx
PRINT TESTS
Tray 1 See “Input source tests” on page 3-9.
Tray 2 (if installed)
Manual Feeder (if installed)
MP Feeder
Prt Quality Pgs See “Print quality test pages (Prt Quality Pgs)” on page 3-10.
HARDWARE TESTS
Panel Test See “Panel Test” on page 3-11.
Button Test See “Button Test” on page 3-11.
DRAM Test See “DRAM Test” on page 3-11.
CACHE Test See “CACHE Test” on page 3-12.
DUPLEX TESTS (if installed)
Quick Test See “Quick Test (duplex)” on page 3-12.
Print Test See “Print Test (duplex)” on page 3-13.
Top Margin See “Top Margin (duplex)” on page 3-14.
Motor Test See “Motor Test (duplex)” on page 3-14.
INPUT TRAY TESTS (if Tray 2 is installed)
Tray 2 See “Input Tray Tests” on page 3-14.
BASE SENSOR TEST
Bin Full Test See “Bin Full Test” on page 3-15.
Sensor Test See “Sensor Test” on page 3-15.
PRINTER SETUP
Defaults See “Defaults” on page 3-16.
PAGE COUNTS This menu contains three submenus: Prt Color Pg Count, Mono Pg Count,
and Perm Page Count. See “Page Counts” on page 3-16.
Serial Number See “Serial Number” on page 3-16.
Engine Setting 1 through 4 See “Engine Setting 1 through 4” on page 3-16.
Model Name See “Model Name” on page 3-16.
Configuration ID See “Configuration ID” on page 3-16.
EP SETUP
EP Defaults See “EP Defaults” on page 3-17.
Fuser Temp See “Fuser Temperature (Fuser Temp)” on page 3-17.
DC Charge Adjust See “DC Charge Adjust, Dev Bias Adj, Transfer Adjust” on page 3-17.
Dev Bias Adj
Transfer Adjust
EVENT LOG
Display Log See “Display Log” on page 3-18.
Print Log See “Print Log” on page 3-18.
Clear Log See “Clear Log” on page 3-19.
EXIT DIAGNOSTICS This selection exits Diagnostics mode, and Resetting the Printer
displays. The printer performs a POR, and returns to normal mode.
Diagnostics mode tests (continued)