• AA Result 7—Coarse data within limits
• AA Result 8—Coarse data deficient
• AA Result 9—Coarse failed to converse
• AA Result 10—Coarse exceeds sense limits
• AA Result 11—Coarse exceeds margin limits
• AA Result 12—Coarse corrections applied
• AA Result 13—Normal exceeds skew limits
• AA Result 14—Coarse exceeds skew limits
• AA Result 15—Coarse new ITU speed
• AA Result 16—AA characterization successfully completed
• AA Result 17—AA characterization
deficient,
using defaults
• AA Result 18—AA manufacturing mode successfully completed
• AA Result 19—AA manufacturing mode deficient, not updating the results
5 Enter the Diagnostics menu, and then navigate to:
Printer setup > EP setup > Toner patch sensor adjust > Full calibration
Note: This triggers the auto align routine (0.42mm—Normal range only).
Action Yes No
Step 1
a From the home screen, touch Settings > Reports > Print
Quality Pages.
b On the CalSet section of the test page, check the color
alignment stat value.
Is the value 0?
Go to step 2. The problem is
solved.
5028
Diagnostic information
237
To Next Page
