LG V-NET ACS PREMTA000A User Manual

167
ENGLISH
166
INSTALLER’S SETTING OPTIONS
● At the Value 1 field, press the ‘▲’, ‘▼’ button to select static pressure selection setting value,
and press ‘Done’ button to apply the static pressure level setting.
- If you do not press ‘Done’ button, your settings will not be applied.
h Static pressure selection setting values
- 01: V - H
- 02: F - H
- 03: V - L
- 04: F - L
h If no buttons are pressed for about 60 seconds after the setting, it automatically exits from the
setting mode.
Static pressure
Function
Operation region ESP default value
Variable high static pressure V - H Variable High static pressure (High)
Fixed high static pressure F - H Fixed High static pressure (High)
Variable low static pressure V - L Variable Low static pressure (Low)
Fixed low static pressure F - L Fixed Low static pressure (Low)
INSTALLER’S SETTING OPTIONS
Ceiling height Function
Low Fan speed operates one step slower than the default value.
Standard Operates at the default fan speed
High Fan speed operates one step faster than the default value.
Very high Fan speed operates two steps faster than the default value.
h If no buttons are pressed for about 60 seconds after the setting, it automatically exits from the
setting mode.
NOTE
!
• Ceiling height setting is only available for certain models.
• Some indoor units may not have a "very high" ceiling option.
• For details, refer to the indoor indoor unit’s manual.
● Press and hold ‘wireless remote controller signal receiver part’ of the remote controller for 3
seconds or longer to enter the installer function.
● At the Code field, select static pressure setting code value ‘06’.
- You can press ‘▲’, ‘▼’ button to change the code value.
Static pressure setting (air conditioner)
Static pressure can be set only for the duct products.
It cannot be set for other products.

LG V-NET ACS PREMTA000A Specifications

General

Brand	LG
Model	V-NET ACS PREMTA000A
Category	Remote Control
Language	English