INSTALLER’S SETTING OPTIONS
189
ENGLISH
188
INSTALLER’S SETTING OPTIONS
Air conditioner Fan operation interlocked with ventilation
(air conditioner)
It is a function that sets the availability of air conditioner FAN movement when only the ventila-
tion is running while air conditioner is off, in case of interlock of the air conditioner operation with
the ventilation operation.
● Press and hold ‘wireless remote controller signal receiver part’ of the remote controller for
3seconds or longer to enter the installer function.
● Select remote controller code value ‘38’.
- You can press ‘▲’, ‘▼’ button to change the code value.
● In value1, use ‘▲’, ‘▼’ button to select setting value, and press ‘Done’ button to complete set-
ting.
- If you do not press ‘Done’ button, the setting value will not be applied.
Value Primary Heater control setting
000 air-conditioner fan off
001 air-conditioner fan operate very low
Indoor unit Auto-Start setting(air conditioner)
It is a function that sets whether to restore the indoor unit operation by resuming the previous
power-on state or as power-off state in the power failure compensation.
● Press and hold ‘wireless remote controller signal receiver part’ of the remote controller for
3seconds or longer to enter the installer function.
● Select remote controller code value ‘39’.
- You can press ‘▲’, ‘▼’ button to change the code value.
● In value1, use ‘▲’, ‘▼’ button to select setting value, and press ‘Done’ button to complete set-
ting.
- If you do not press ‘Done’ button, the setting value will not be applied.
Value Primary Heater control setting
000 Use indoor unit auto restart
001 Not use indoor unit auto restart
To Next Page
Loading...
Need help?
General
