191
ENGLISH
INSTALLER’S SETTING OPTIONS
● Press and hold ‘wireless remote controller signal receiver part’ of the remote controller for 3
seconds or longer to enter the installer function.
● Select remote controller Celsius control unit setting code value ‘05’.
- You can press ‘▲’, ‘▼’ button to change the code value.
● In value1, use ‘▲’, ‘▼’ button to select product direction setting value, and press ‘Done’ button
to complete the setting.
- If you do not press ‘Done’ button, the setting value will not be applied.
Product direction (General ventilator)
It is the function to set the direction of the ventilation product.
h Product direction setting value
- 01: normal
- 02: reverse
h If there is no button input for about 60 seconds after the setting, it automatically exits from the
setting mode.
190
INSTALLER’S SETTING OPTIONS
Occupancy Duration Time Setting(air conditioner)
It is a function that sets the light-on/occupancy duration after motion is detected when installing
an occupancy sensor.
● Press and hold ‘wireless remote controller signal receiver part’ of the remote controller for
3seconds or longer to enter the installer function.
● Select remote controller code value ‘40’.
- You can press ‘▲’, ‘▼’ button to change the code value.
● In value1, use ‘▲’, ‘▼’ button to select setting value, and press ‘Done’ button to complete set-
ting.
- If you do not press ‘Done’ button, the setting value will not be applied.
Value Occupancy Duration Time
000 0 minute
001 10 minutes
002 30 minutes
003 60 minutes
To Next Page
Loading...
Need help?
General
