liftup FlexStep V2 - Audible Alarms

INSTALLATION & SERVICE MANUAL – FLEXSTEP V2– UK VERSION
1.7
Liftup A/S Hagensvej 21| DK-9530 Støvring | Denmark | T: +45 96 86 30 20 | M: support@liftup.dk | www.liftup.dk | CVR DK-1015 3964
50
7.5 Audible alarms
If “speak” is installed on the lift this will be activated in the event of an alarm. Otherwise an
alarm tone will sound.
Speak
Activity/warning
Opening
The vertical safety barrier is opening.
   
Closing
The vertical safety barrier is closing.
   
Overload alarm
The platform is overloaded.
  _   _ 
Battery fault – the lift cannot be
used
The battery has a fault.
Inadequate power supply (please see
section 5 Technical Specifications).
  _   _ 
Alarm – something is under the
lift
Remove the object under the lift
which is preventing downward
movement.
_   _   
Alarm – something is on the lift
Change from platform to staircase is
not possible because
someone/something is on the
platform.
_   _     
Ding Ding Ding
Arriving at top/bottom level.
  
Ding Ding Ding
The lift has become a staircase.
  
Warning – automatic operation
A warning that the lift has to become
a staircase.
     
BEEP-BEEP-BEEP…
The lift is in the process of becoming
a staircase.
             
Emergency stop pressed
The red emergency stop button has
been pressed in. This must be
released in order that the lift can
function again.
    
The lift is locked
The lift is locked with a key switch.
    
Battery warning
Low battery level.
     
Power supply is interrupted –
connect or press emergency
stop
Connect to a power supply or
activate emergency stop in order to
power off the lift.
     
Inspection due
Call your service technician:
http://www.liftup.dk/en/distributors/
       
  High tone followed a deeper Tone
  Low Tone followed by Higher Tone
   Identical Tones (3 off)