liftup FlexStep V2 - Disassemble the Flexstep V2; Place the Flexstep V2 on a Plane Surface

INSTALLATION & SERVICE MANUAL – FLEXSTEP V2– UK VERSION
1.7
Liftup A/S Hagensvej 21| DK-9530 Støvring | Denmark | T: +45 96 86 30 20 | M: support@liftup.dk | www.liftup.dk | CVR DK-1015 3964
52
8 Disassemble the FlexStep V2
8.1 Place the FlexStep V2 on a plane surface
Use a table, or place the Flexsep V2 on the floor. It is important that the steps and girders
are in the same level, to ensure that the wires won’t be cut when the steps are loosened
from the girders. (see more at 8.3)
Table or plane surface