INSTALLATION & SERVICE MANUAL – FLEXSTEP V2– UK VERSION
1.7
Liftup A/S Hagensvej 21| DK-9530 Støvring | Denmark | T: +45 96 86 30 20 | M: support@liftup.dk | www.liftup.dk | CVR DK-1015 3964
8.2 Disconnecting the wires
Disconnect the following wires from the master control board, RH side mounted.
Disconnect wires from actuators
Disconnect wires from actuators
Disconnect wire from control panel
Disconnect wire from IR sensors
Disconnect the following wires from connectors:
Disconnect the power cable for the SLAVE actuator (1,2,3) from
connector
To Next Page
Loading...
