INSTALLATION & SERVICE MANUAL – FLEXSTEP V2– UK VERSION
1.7
Liftup A/S Hagensvej 21| DK-9530 Støvring | Denmark | T: +45 96 86 30 20 | M: support@liftup.dk | www.liftup.dk | CVR DK-1015 3964
10.3 Pull Force
Recommended strength of screw attachment when installing wall profiles
Screws attached to the building must withstand a Pull Force not less than 0.5 kN each.
(See next page forexamples of screw attachments)
Minimum three screws must be used for each Wall Profile.
Note: If the strength of screw, attachment is validated by test, minimum withdrawal
strength is 1.5 kN.
To Next Page
Loading...
