MMX8x4-HT series – User's Manual 160
Set the Duck on the Emb. Audio In
ç <duck_status>
Set the Highpass Filter on the Emb. Audio In
ç <hpf_status>
ç <lpf_status>
ç <eq_nr><gain_value>
Advanced Analog Audio Output
Mute the Analog Audio Out
ç <mute_status>
ç <volume_dB>
ç
ç
Set the Balance on Analog Audio Out
ç <bal_set>
Set the Phase Invert on Analog Audio Out
ç <invertphase_status>
Set the Mono Function on Analog Audio Out
ç <mono_status>
Set the Delay on Analog Audio Out
ç <delay_status>
Set the Delay Time on Analog Audio Out
ç <delay_time>
ç <eq_nr><gain_value>
Audio Presets
Save a Preset
ç <ch>:savePreset(<index>,<target_node>,<name>)
ç <ch>:loadPreset(<index>,<target_node>)
Delete a Preset
ç <ch>:deletePreset(<index>)
Audio Scenes
Change the Scene Name
ç SET·<scene_id><scene_name>
Save a Scene
ç ·<index>,I9,I10,I11,O6,<scene_name>)
ç <index>,I9,I10,I11,O6)
Delete a Scene
ç ·<index>)
Protocol Setting
ç <serial_port><cont_protocol>
BAUD Rate Setting
ç <serial_port><baudrate>
Operation Mode Setting
ç <serial_port><rs232_mode>
Command Injection Mode
ç <serial_port><ci_stat>
ç <serial_port>.CommandInjectionPort
Serial Port Messaging
Sending a Message (ASCII-format) via RS-232
ç <message>)
Sending a Text (ASCII-format) via RS-232
ç <message>)
Sending a Binary Message (HEX-format) via RS-232
ç <message>)