Service Training
Page 39
Section 4.1
09.06
- Read off ID number for injection pump length (dimension
A) for the new injection pump.
NOTE: Determining new shim.
- Place newly determined shim on roller tappet
.
- Turn injection pump steering lever to center position
more or less.
- Apply AP 1908 compound to location hole in crankcase
and to O-rings of injection pump. Mount injection pump
and insert injection pump steering lever carefully into
control rod.
NOTE: The roller tappet for the respective injection
pump must be on the base circle of the
camshaft.
To Next Page
Loading...
