Operation 4
Special equipment
¾ Press the
*
(4) button to start the input
device.
The green LED (2) flashes.
¾ Enter personal PIN (factory se
tting =
0 0
0 0 0
).
NOTE
If the PIN was input incorrectly, press the
*
button (4) and enter the correct PIN.
¾ Confirm the entry with the
#
b
utton (3).
The green LED (2) lights up with a steady light.
NOTE
If the red LED (1) light
s up, an incorrect PIN
was entered. Press the
*
button (4) and enter
it again. If more than t
hree incorrect entries
are made (factory sett
ing), the red LED (1)
lights up and the green
LED (2) flashes. The
input of a valid PIN is b
locked for 10 minutes.
Theblockingtimecan
be interrupted by
inputting a special P
IN. Please contact your
fleet manager.
¾ Rotate the turning knob (6) clockwise to the
stop and start the truck.
NOTE
If the truck does not start properly the first time,
the starting procedure can be repeated until
the turning knob (6) is returned to the zero
position, and the PIN is discarded after expiry
of the delay time.
NOTE
If the green (2) and red (1) LEDs both light up
as steady lights, the data must be read out.
Please inform your fleet manager at once.
Operating Instructions – 394 807 10 01 EN – 07/2011 85
To Next Page
Loading...
