LINET GRACIE - Page 142

142/150 D9U001GKB-0101
Problem
description
Probable cause
Activities of the
operator to
correct the
problem
Activities of the
qualified service
personnel
Seat part heating
does not operate.
Power cable
located under the
seat part and
leading to the seat
heating base plate
is connected
insufficiently.
Remove the seat
part and make sure
that the cable is
connected.
Check whether the
heating operates
with other base
plate. If so, replace
the base plate.
5 LED indicators of
the seat part
heating flash and a
warning signal
sounds.
Seat part is
overheated.
Let the seat part
cool down for
approx. 1 hour.
Check whether the
seat gets
overheated with
other base plate. If
so, replace the
base plate.
4 LED indicators of
the seat part
heating flash.
Seat part is
defective or badly
connected to the
base plate.
Remove the seat
part and make sure
that the cable is
connected.
Check whether the
heating operates
with other seat
connected. If so,
replace the seat.
3 LED indicators of
the seat part
heating flash.
This is an internal
error of the control
device.
Remove the seat
part and make sure
that the control
device cable is
properly
connected.
Check whether the
heating operates
with other control
device
connected. If so,
replace the control
device.