LINET Multicare X User Manual

D9U001MCX-0101_03
35
8.6 Before Use
Prepare the bed for use as follows:
► Connect the bed to the mains.
► Charge the accumulator.
► Raise and tilt the mattress support platform to the highest position.
► Lower and tilt the mattress support platform to the lowest position.
► Check that the castors as well as main brake work correctly.
► Check that the bed extension works correctly.
► Check that it is possible to remove the head board and foot board.
► Check all of the functions on the control elements.
► Check that the siderails function properly.
► Dispose of all packaging (see Disposal).
8.7 Transport
For a safe transport, observe the following:
► Ensure that no cables are run over when moving a bed.
► Ensure that the mains cable is attached with a hook (at the head end of the bed).
► Ensure that the castors are unlocked before moving the bed during the loading/unloading process (see Castor Control).
► Adjust bed height to at least 20 cm below maximum height.
► Push bed by handles on head board or foot board.
► Move the bed exclusively on suitable oor surfaces.
► Ensure the bed is braked when it is not transported.
► For longer distances, ensure that the castor steering function (main control) is activated.
► Ensure that the brakes are released while moving the bed.
Suitable surfaces:
■ Tile
■ Hard linoleum
■ Poured ooring
Unsuitable surfaces:
■ Too soft, unsealed or defective ooring
■ Soft wooden ooring
■ Soft and porous stone oors
■ Carpeted oors with underlay
■ Soft linoleum
To avoid damaging the bed and the environment during transport or storage:
► Activate Bed Transport Mode on the Attendant Control Panel.
To activate Bed Transport Mode:
► Disconnect the bed from the mains.
► Disconnect the ground wire.
► Activate the keypad by pressing the button
on the Attendant Control Panel.
► Press the Thighrest Up button + Thighrest Down button + Trendelenburg Tilt button at the same time and hold them for
three seconds.
The Bed Transport Mode is activated.
To deactivate Bed Transport Mode:
► Connect Power Cable to the mains.
8.7.1 Bed Transport Mode

LINET Multicare X Specifications

General

Brand	LINET
Model	Multicare X
Category	Medical Equipment
Language	English