LINET OptiCare - Full Cleaning and Disinfection; Removing the Mattress Cover

D9U003VS0-0101_01
54
► Let mattress dry or wipe dry.
► Wipe mattress with disinfectant.
► Rinse mattress with cold water.
► Let mattress dry or wipe dry.
Cleaning the SCU:
► Wipe SCU with disinfectant.
► Let SCU dry or wipe dry.
13.2 Full Cleaning and Disinfection
Cleaning the mattress:
►, Deate mattress and remove cover (see Removing the Mattress Cover).
► Check mattress cover top and base for any signs of damage.
Replace or repair and completely disinfect mattress cover top and base if damaged.
► Check mattress cover top and base for signs of liquid ingress.
Replace or clean and completely disinfect mattress cover top and base if damp inside.
► Clean all mattress cells and pipes with 60°C warm water and cleaning detergent.
► Rinse mattress with cold water.
► Let mattress dry air dry or wipe dry.
► Wipe mattress with disinfectant.
► Rinse mattress with cold water.
► Let mattress dry air dry or wipe dry.
Cleaning the mattress cover:
► Remove cover (see Removing the Mattress Cover).
► If machine washing mattress top/base covers, the temperature should be raised during the wash cycle, to 65°C/149°F,
for 10 -15 minutes, or 71°C/160° F, for 3 - 10 minutes, using hospital approved detergents and rinsing agents.
NOTE Maximum wash temperature 75°C/167°F.
► Dry cover in tumble dryer at low temperature.
Cleaning the air pipe:
► Wipe air pipe with cleaning agent or disinfectant.
► Let air pipe dry.
Cleaning the SCU:
► Remove lter.
► Wipe SCU and lter with disinfectant.
► Let SCU and lter dry.
► Reinsert lter.
13.3 Removing the Mattress Cover
► Carefully open zipper under side skirt of mattress cover on foot end of mattress.
► Remove top part of mattress cover.
► Undo corner toggles holding comforter cover and remove comforter cover.
Inspect comforter cover and clean if necessary.
► Undo toggles holding top deck to foam base.
► Undo plastic clip next to air pipe inlet on base cover holding foam base to cover.
► Remove bottom part of mattress cover.
After cleaning the mattress cover:
► Reinstall mattress cover by reversing the process described above.
► Make sure all toggles are put back in their respective holes.
General guidance – Slippy Cover
WARRANTY Due to the nature and MVP (Moisture Vapor Permeability) rating of the Slippy Cover Material, the Warranty is 1
year. Chemical damage caused by using aggressive or incorrect cleaners will not be accepted under the warranty
LIFESPAN Typically 50 cleaning cycles in accordance with manufacturers’ instructions.