14
Setup
Linksys
Range:
If the DMZ and WAN are within same subnet:
IP Range: Input the IP range located at the DMZ port.
Setting Password
Use the Configuration > Setup > Password page to change the administrator
username and password. It is strongly recommended to change the default
username and password (admin/admin).
CAUTION If the password is forgotten, reset the router to factory default
settings. All the configurations of the router will disappear.
NOTE Remember to click Save to save your settings before leaving the page.
You can also click Cancel to leave without any change.
NOTE If you want to enable remote access on the Firewall > General setting,
changing your password is necessary.
Old Password: Enter the old password. The default
password is admin.
New Username: Enter a new username. To keep the
existing username, leave this field blank.
Confirm New Username: Re-enter the new username.
New Password: Enter a new password for the router.
Alphanumeric characters and symbols
are allowed, but no spaces.
Confirm New Password: Re-enter the new password.
Minimum
Password Complexity:
Check the box to enable box if you want
to enforce password complexity and
enable the Password Strength Meter.
This option is enabled by default and is
recommended.
NOTE When Minimum Password Complexity is enabled, the password must
meet the requirements listed below.
• At least 8 characters is must.
• The password cannot be the same as Username.
• The password cannot be the same as the current password
• Must contain characters from at least 3 of the following 4 categories:
uppercase letters, lowercase letters, numbers, and special characters
available on a standard keyboard.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
