Linksys LRT214 User Manual

27
DHCP
Linksys
IP & MAC Binding (for IPv4 Only)
IP & MAC Binding assigns IP addresses to specific devices. In this way, you can
also make sure that users can not add extra PCs for Internet access or change
private IP addresses.
NOTE Remember to click Save to save your settings before leaving the page.
You can also click Cancel to leave without any change.
IP & MAC Binding
• Set up IP & MAC Binding from IP & MAC Table
Click Show unknown MAC addresses button, an IP address and MAC table
will appear. Input a name for the device and check Enable box to bind the IP
and MAC addresses.
Click OK to save the configuration or Close to leave without saving. You can
also click Refresh to update the table.
-SetupIP&MACBindingManually

Linksys LRT214 Specifications

General

Color	black/blue, multi
Wi-Fi Mesh System	no
Frequency Band	not applicable
Ethernet Standard	10/100/1000
Gigabit Ethernet Speed	yes
Firewall	nat, spi
Ports	rj-45
LAN Ports	4
Built In Modem	yes

Weight and Dimensions

Height	1.6 inches
Width	7.5 inches
Net Weight	1.6 pounds