Linksys LRT214

22
Setup
Linksys
Dynamic DNS
With Dynamic Domain Name System (DDNS) service offers the function of
dynamic web address transferred you can assign a domain name to a dynamic
WAN IP address. This function will benefit VPN connection, website, FTP or
other TCP/IP service in dynamic IP address network. Use the Configuration
> Setup > Dynamic DNS page to configure the WAN interfaces with your
Dynamic DNS information.
You have to go to DynDNS.org (www.dyndns.org) or 3322.org (www.3322.org)
to register a domain name before configuring DDNS function.
NOTE Remember to click Save before leaving the page. You can also click
Cancel to undo the changes.
Click Edit icon for the WAN interface to continue.
Dynamic DNS Setup
The Dynamic DNS Setup page appears after you click Edit icon on the
Dynamic DNS page.
NOTE Remember to click Save to save your settings before leaving the page.
You can also click Cancel to undo the changes.
Interface: Indicates the WAN port the user has selected.
Service: Check the box to choose your service (DynDNS.org or
3322.org).
Username: Input the username for your DDNS account.
If you have not previously registered a host name,
click Register to go to the website to sign up for DDNS
service.
Password: Enter the password for your account.
Host Name: Use these three fields to enter the host name you
registered.
Examples are abc.dyndns.org or xyz.3322.org.
WAN IP Address
(Read only)
Input the actual dynamic IP address issued by your ISP.
Status
(Read only)
Indicates the status of the current IP function refreshed
by DDNS.
Advanced Routing
Use the Configuration > Setup > Advanced Routing page to configure the
dynamic and static routing.
NOTE Remember to click Save to save your settings before leaving the page.
You can also click Cancel to undo the changes.
• ClicktheIPv4 or IPv6 tab.
• DynamicRouting
• StaticRouting
• ClickViewatthebottomofthepagetochecktheroutingtable.Click
Refresh to update the data, or click Close to close the pop-up
window.