21
Setup
Linksys
Enabled One to One NAT: Check to enable the One-to-One NAT function.
Private Range Begin: Input the Private IP address for the Intranet
One-to-One NAT function.
Public Range Begin: Input the Public IP address for the Internet
One-to-One NAT function.
Range Length: Input the numbers of final IP addresses of
actual Internet IP addresses. (Please do not
include IP addresses in use by WAN ports.)
Add to List: Add this configuration to the One-to-One NAT
list.
Update: Select the entry that you want to modify.
Change the setting and click Update. Clicking
Add New will deselect the entry and clear the
text fields.
Delete: Click the entry and then click Delete.
Setting MAC Clone
Some ISPs ask for a fixed MAC address (network card physical address) for
distributing IP addresses. Users can input the network card physical address
(MAC address: 00-xx-xx-xx-xx-xx) here. The Linksys LRT series router will adopt
this MAC address registered to your ISP. Use the Configuration > Setup > MAC
Address Clone page
Click Edit to get into configuring page.
MAC Clone Settings
NOTE Remember to click Save before leaving the page. You can also click
Cancel to leave without any change.
To clone a MAC address, enter the following settings. Select the interface you
want to configure if the router supports dual WAN ports.
User Defined WAN MAC Address: Check this item to manually clone a
MAC address. Enter the 12 digits of the
MAC address that you registered with
your ISP.
MAC Address from this PC: Check this item to clone the MAC
address of the device you are currently
using.
The MAC address of your PC is
displayed automatically.