Linksys LRT214 User Manual

30
System Management
Linksys
System Management
You can configure advanced setting in System Management category, please
refer to following items:
• DualWAN(LRT224Only)/NetworkServiceDetection
• BandwidthManagement
• SNMP
• SSLCertificate
Dual WAN (LRT224 Only) / Network
Service Detection
Dual WAN
You can choose Link Failover or Load Balance mode when you use Dual WAN
setting. Go to Configuration > System Management > Dual WAN.
NOTE Remember to click Save before leaving the page. You can also click
Cancel to undo the changes.
Mode
You can configure two Internet connections by using the WAN and the WAN/DMZ port.
Two modes can be selected:
Link Failover: Only the primary WAN port works in normal time; the
other WAN is a backup port.
If the primary WAN connection is unavailable, the backup
WAN connection will take over the traffic.
Load Balance: Two WAN ports will work simultaneously. The router will
balance traffic between the two ports.
Network Service Detection
This is a detection system for network external services. If this option is selected,
information such Retry or Retry Timeout will be displayed. If two WANs are
used for external connection, be sure to activate the NSD system, so as to avoid
any unwanted break caused by the device misjudgment of the overload traffic
for the WAN.

Linksys LRT214 Specifications

General

Color	black/blue, multi
Wi-Fi Mesh System	no
Frequency Band	not applicable
Ethernet Standard	10/100/1000
Gigabit Ethernet Speed	yes
Firewall	nat, spi
Ports	rj-45
LAN Ports	4
Built In Modem	yes

Weight and Dimensions

Height	1.6 inches
Width	7.5 inches
Net Weight	1.6 pounds