LiveU Live Video Uplink System User Guide
20
Step 1, Turning On the LU Device
The following describes the procedure for turning on the LU60/LU70 family of
devices.
LU60/LU70 – Turning On the Device
The LU60/LU70 device is provided by LiveU with a charged battery already
inserted.
NOTE
If required, you may refer to Changing the LU60/LU70 Battery section
on page 122 for a description of how to replace the battery or to the
Charging the LU60/LU70 Battery section on page 121
on how to charge the battery.
IMPORTANT
For DV cameras, it is recommended to first power on the
LU60/LU70 as described below, and then to connect the
camera. SDI, HDMI or Analog cameras can be connected
either before or after powering on the LU60/LU70.You may
refer to Connecting the Camera section on page 129, for
instructions on connecting the camera.
For DV cameras, it is recommended to first power off the DV
camera, to connect the camera to the LU60/LU70 and then to
power on the camera. SDI, HDMI or Analog cameras can be
powered on either before or after being connected to the
LU60/LU70.
These instructions are also provided in the appropriate place in
the procedures that follow.
To Next Page
Loading...
