LKC TECHNOLOGIES RETeval - Device Maintenance and Integration; Managing Stored Test Data

Additional Activities
RET eval Device User Manual 23
Additional Activities
Removing old results from the device
The RET eval device can store up to 50 test results. You must remove old results to make room
for new tests. There are three ways to remove results.
WARNING: Results deleted on the device cannot be recovered. Save results you want to keep
on a PC before deleting them off the RET eval device.
Removing Selected Results from the Device
To remove individual results from the device, follow these steps:
Step 1. Make sure that any results you want to keep have been copied to the PC.
Step 2. Turn on the RET eval device.
Step 3. Select Results.
Step 4. Select the desired result to be erased.
Step 5. Select Delete.
Step 6. Select Yes.
Removing All Results from the Device
To remove all stored results from the device, follow these steps:
Step 1. Make sure that any results you want to keep have been copied to the PC.
Step 2. Turn on the RET eval device.
Step 3. Select Settings then Memory.
Step 4. Select Erase all test results.
Step 5. Select Yes.
If during Step 4 you chose Erase everything, then the data storage area (including patient
results and custom protocols) would be deleted and reset to factory condition.
Removing Results Using the PC
To remove results from the device using a PC, follow these steps:
Step 1. Place the RET eval device into the docking station.
Step 2. Connect the USB cable.
Step 3. Wait for the device to appear as an external drive on the PC.
Step 4. Navigate to the Reports directory on the device.
Step 5. Make sure that any results you want to keep have been uploaded to the PC. Copy the
files just as you would copy any file from a thumb drive or other external device to a PC.
If desired, also copy the corresponding raw data file (.rff) and XML file (.rffx) from the