CHAPTER 6: OPERATION 79
QUICK LOAD SERVO 80 S2
5.2.4. Miscellaneous functions
Language selection
This parameter allows to adapt the language in which the
messages will appear, depending on the country of destination of
the bar feed system (for practical reason, it is not necessary to stop
the bar feeder to select a language).
Unit of measure (millimetres / inches)
This parameter defines whether the measures will be indicated in
millimetres or in inches.
Request for reference point
This operation allow the bar feed system to find the original position
of the servo motor and the parameters when and if these have been
lost.
Clamping mode reversed
When the clamping device is changed from a collet to a chuck with
jaws, the clamping signal may need to be reversed. Note that some
lathes automatically reverse the signal.
Time for clamping device to close
This is the time it takes for the clamping device to be physically
closed. The majority of CNC lathes are equipped with confirmation
switches to provide this signal. The time is set at a default value of
zero seconds.
Time for clamping device to open
In the case of a clamping device with jaws, some time may be
provided to prevent any movement before the clamping device is
completely open.
LANGUAGE: [@]
1:FRANÇAIS
2:ENGLISH
3:DEUTSCH
4:ITALIANO
5:ESPANOL
ESC ENTER
REQUEST FOR
REFERENCE POINT:
[@]
1:NO
2:YES
ESC ENTER
CLAMPING MODE
REVERSED: [@]
1:NO
2:YES
ESC ENTER
UNIT OF MEASURE:
[@]
1:MM (METRIC)
2:INCHES
ESC ENTER
TIME FOR CLAMPING
DEVICE TO CLOSE:
[@.@]SEC.
ESC ENTER
TIME FOR CLAMPING
DEVICE TO OPEN:
[@.@]SEC.
ESC ENTER
To Next Page
Loading...
