LNS QUICK SIX - A049 - Measuring Cell SQ@ Is Activated too Early

1-22 Chapter 1: Alarms
QUICK SIX
A049 – Measuring Cell SQ@ is Activated too Early
MEASURING CELL SQ@
IS ACTIVATED TOO
EARLY!
POSSIBLE CAUSES:
- BAR STOCK EXCEEDS
MAXIMUM SAFETY
LENGTH
- BAR STOCK LIMITERS
NOT IN CORRECT
LOCATION A049
Description:
The Measuring Cell SQ@ is Activated Too Early alarm occurs during the loading cycle if input signal (I0.7 – SQ1) turns on too early.
Solution:
 Verify that the length of the bar that was loaded should not exceed 6’4”.
 The pusher is not cut to proper length or does not correspond to the “Length of Feeding Pusher.”