LNS QUICK SIX - A053 - Lathe DID Not Resume Its Production Cycle

1-24 Chapter 1: Alarms
QUICK SIX
A053 – Lathe Did Not Resume Its Production Cycle
LATHE DID NOT
RESUME ITS
PRODUCTION CYCLE!
POSSIBLE CAUSES:
-LATHE CLAMPING
DEVICE NOT CLOSED
-CLAMPING
CONFIRMATION SIGNAL
MISSING (INTERFACE,
PLC INPUT A1)
Description:
The Lathe Did Not Resume Its Production Cycle alarm occurs if the bar feed does not recognize the chuck signal input (I3.0 – A1)
within 1 minute after reaching top-cut position.
Solution:
Alarm needs to be cleared. Press the STOP key on the remote control station to clear the message and reset the alarm. Restart the
bar feeder and the lathe automatic cycle.