Chapter 4: Software Update/Restore 4-5
Step 10: When the PLC fault screen appears (seen below) press the F3 key (ENTER).
Step 11: Press F3 (ENTER) on the first screen that displays to Restore PLC Program from Memory Card to PLC.
Step 12: The PLC program will now be saved from the memory card to the PLC. This may take several minutes.
Step 13: Press F4 (OK).
Step 14: Turn off power to bar feeder.
Step 15: Move the RUN/STOP switch to RUN position.
Step 16: Restore power to the bar feeder.
Procedure complete.
QUICK SIX
To Next Page
Loading...
