ZENIT
69
REPORTS AND DIAGNOSIS
Spindle Blocking - Display / Reset
Machine Type Display on Winding Unit Reset
Murata 21C
Start switch is lit in yellow
To start spindle: Turn the Start switch by 180 degrees
Orion
Polar
Smaro
Spindle is lit in red (red light blinks)
Alarm reset: Push black button
To start spindle: Push white button
Espero i
VJ Excello
Espero Nuovo
Spero
Spindle is lit in red (red light blinks)
Alarm reset: Push red button
To start spindle: Push green button
EJP 438
DTM 439
Spindle is lit in red and yellow (textile alarms)
Red light blinks (technical alarms)
Alarm reset: Push on red light
The bobbin is ejected, the fault length is suctioned off
and winding continues automatically (textile alarms)
AC 238 / 146
Spindle is lit in red and yellow (textile alarms)
Red light blinks (technical alarms)
Alarm reset: Perform TK reset
To start spindle: Turn switch
AC 238 / 147
Spindle is lit in red and yellow (textile alarms)
Red light blinks (technical alarms)
Alarm reset: Push on red/yellow light
The bobbin is ejected, the fault length is suctionned off
and winding continues automatically (textile alarms)
To Next Page
