QUICK START
Logicube ZClone™Xi User’s Manual 19
2. Next, set the Clone task. Select Drive to Drive as the Mode. Select M1 as the
Master. Change the settings as needed. Select T1 as the Target. Do not start
this task.
3. Choose Task Macro from the list of operations on the left side.
4. Tap the Tasks icon to select the different tasks for the macro.
5. Tap the field next to Operation 1 to set the first operation. Since the first task
to be run is the Wipe task, select Wipe 1 then tap OK.
6. Tap the field next to Operation 2 to set the second operation. Since the
second task to be run is the Drive to Drive Clone task, select Clone 1 then tap
OK.
7. The screen should now show Wipe 1, Clone 1 as the Tasks for the macro.
To Next Page
