12
3. Press the buttons to select the correct HDMI
resolution for your TV and then press the OK
button to conrm.
First Time Installation
1. When your unit is switched on for the rst time,
it will go straight into the First Time Installation
menu.
Low Power Standby Mode
When the unit is in On mode, press the Standby once, the unit will enter the active standby
mode and the power indicator will illuminate red. To turn the unit on again, press the button
again. The power indicator will illuminate green.
The unit enters low power standby mode after approximately 1 minute. The LED display will be
blank.
To turn the unit on again, press the Standby to turn the unit on, the power indicator will
illuminate green. It may take a minute until the unit is initialised.
• If you press the Standby button during recording or if any EPG programme
recordings and/or manual recordings are set, the unit does not switch to low
power mode and remains in active standby mode until recording tasks have been
nished.
• The unit initializes from time to time to receive updates from the EPG broadcast in
order to synchronize EPG recording tasks properly. After getting updates, the unit
switches to low power mode automatically. This takes a short while and it is not a
malfunction.
The unit will take a while to load.
2. Press the buttons to select the TV type and
then press the OK button to conrm.
L1HSTB12_IB_120725_CS4_Edits_Pauline.indd 12 30/07/2012 14:57
To Next Page
Loading...
General