9
Battery Replacement of the Remote Control
1. Squeeze the cover lever and lift the
battery cover to access the battery
compartment of the remote control.
2. Insert two AAA size batteries (included).
Ensure the polarities (+ and –) of the
batteries match the (+) and (–) ends
indicated in the battery compartment.
3. Close the battery compartment cover.
Handling the Batteries
• Improper or incorrect use of batteries may cause corrosion or battery leakage, which could
cause re, personal injury or damage to property.
• Only use the battery type indicated in this manual.
• When the batteries are exhausted, the remote will not function. Replace both batteries at
the same time with new ones.
• Do not install new batteries with used ones and do not mix dierent types of batteries.
• Do not dispose of used batteries as domestic waste. Dispose of them in accordance with
local regulations.
Handling the Remote Control
• Take care of your ngernails when you press and hold the battery release tab.
• Do not drop or cause impact to the remote control.
• Do not spill water or any liquid on the remote control.
• Do not place the remote control on a wet object.
• Do not place the remote control under direct sunlight or near sources of excessive heat.
• Remove the battery from the remote control when not in use for a long period of time, as it
could cause corrosion or battery leakage and may result in physical injury and/or property
damage including re.
Remote Control Operation Range
Keep the remote control within approx. 5 metres of the
remote control sensor on the unit and within 60° in front
of the unit. The operating distance may vary depending
on the brightness of the room.
PIP–
Standby MUTE
WIDE
1.,?* 2abc 3 def
4ghi 5jkl 6mno
7pqs 8tuv 9wxyz
TEXT
i
0&@_
SWAP
TIMERS
LANG(AD)
SUBTITLE
LIB
PIP
PIP+
TV/RADIO
AV
P+VOL+
P–VOL– FAV
EXIT
GUIDE
BACK
P<P
MENU
OK
30° 30°
5M
1
3
2
L1HSTB12_IB_120725_CS4_Edits_Pauline.indd 9 30/07/2012 14:57
To Next Page
Loading...
General