Recording9
9.4.3 Configuring Video Motion Detection
Video motion detection looks for changes in video images (frames) to detect motion. Vid-
eo motion detection allows for motion detection beyond the range of the PIR sensors.
The drawback to video motion detection is that it can sometimes be falsely triggered by
changes in lighting conditions or trees moving in the wind. You can disable video motion
detection or configure the sensitivity using the menus. It is recommended to enable video
motion detection and set a lower sensitivity if you are experiencing false triggers.
For a description of the two motion detection technologies used by the system, see 9.4
Motion Recording, page 29.
To configure video motion detection:
1. Tap
, then go to General Settings > Motion Detection Settings. The Setup mo-
tion detection sensitivity of day time for selected camera screen appears.
2. Under camera 1, select Off to disable video motion detection, or select Low, Medium,
or High sensitivity.
NOTE
Repeat this step for each connected camera.
3. Tap to save your changes.
#LX400069; r.28523/28523; en-US
31
To Next Page
Loading...
Need help?
General
