Scan Mode
11
In Scan mode, the receiver’s LCD screen and speaker will turn off unless motion is de-
tected by one of the cameras. The LCD screen turns on and displays video from the cam-
era where motion was detected for 15 seconds before turning off again. This conserves
battery power and alerts you only when needed.
You can configure how much motion is needed to turn the display on in Scan mode by
changing a camera’s video motion detection settings. See 9.4.3 Configuring Video Motion
Detection, page 31.
To enable Scan mode:
1. In live view mode, press and release the power button (
) on top of the receiver.
NOTE
The power indicator LED on the side panel of the receiver glows indicating the receiver is in scan
mode.
2. Press and release the power button again to exit Scan mode.
NOTE
When exiting Scan mode, the receiver resumes live viewing in Auto Sequence Viewing mode.
#LX400069; r.28523/28523; en-US
38
To Next Page
Loading...
Need help?
General
