Network Setup (This Section is for Advanced Users Only)
14
To enable static IP addressing:
NOTE
• A static IP address is not required for remote access to the system.
• You may have to configure your router settings if the DHCP server is enabled.
1. Tap , then go to General Settings > Network Setup > Advanced Setup.
2. Tap Static IP. A Static IP configuration screen appears.
3. Tap the text box next to the IP Address field. A virtual numeric keypad appears on
screen.
NOTE
• 1: Number Keys
• 2: Backspace
• 3: Confirm entry
4. Tap each value inside the text box to move the cursor.
#LX400069; r.28523/28523; en-US
45
To Next Page
Loading...
