LSI GS550 - Advanced Radius Parameters

2. Operation 33
2.6.5 Advanced Radius Parameters
Figure 16 Advanced Radius Parameters
Extensions, two possibilities:
1) Manual length (4C16): The offset is
always zero degrees.
2) Lattice extension length(4C15):
The offset angle must be adjusted.
4C15) Lattice extension
length
4C9) Lattice extension offset
angle is also used for
h
y
draulic crane
4C5) Boom top
len
g
th
4C6) Boom
top offset
angle
4C5) Boom length
includes boom top
Typical sheave heads:
• 4C17) Sheave head length perpendicular =
D1
•
4C18
)
Sheave head len
g
th
p
arallel = 0
Special top sheaves
(example: rooster):
• 4C17) Sheave head
length perpendicular
= D2
• 4C18) Sheave head
length parallel = D3
4C14) Luffing jib length (center sheave to
center sheave
)
4C13) and 4C11) Fixed jib length & offset angle
4C10) and 4C11) Jib mounting point parallel &
perpendicular
4C9) and 4C15) Lattice extension length & offset
an
g
le
4C2) Slew
offset.
Boom heel
pin
4C5) Boom length
includes boom top
4C14)
Luffing jib
angle
sensor
4C5) and 4C6) Boom top length & offset
an
g
le
4C1) Main boom
4A1) Boom angle
senso
r