66 The GS550 System
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is con-
nected.
Consult the dealer or an experienced radio/TV technician for help.
In order to maintain compliance with FCC regulations, shielded cables must be used with this
equipment. Operation with non-approved equipment or unshielded cables is likely to result in
interference to radio and TV reception. The user is cautioned that changes and modifications made
to the equipment without the approval of manufacturer could void the user's authority to operate
this equipment.
FCC ID: QVBGS550 IC: 7076A-ICGS550
RF Exposure Warning:
This product complies with FCC/IC radiation exposure limits set forth for an uncontrolled
environment. To comply with RF exposure requirements, the unit must be installed and op-
erated with 20 cm (8 in.) or more between the product and your body. This product may not
be collocated or operated in conjunction with any other antenna or transmitter.
This device has been designed to operate with the antennas listed below, and having a
maximum gain of 2.0 dBi. Antennas not included in this list or having a gain greater than 2.0
dBi are strictly prohibited for use with this device. The required antenna impedance is 50
ohms.
To reduce potential radio interference to other users, the antenna type and its gain should
be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that
permitted for successful communication.
Antenna List
LSI P/N: TA001 LSI P/N: TA008
Description ¼ wave monopole Description ½ wave dipole
MFG Linx Technologies MFG: Nearson
P/N ANT-916-CW-QW P/N: S467AH-915S
FCC ID: QVBGS000 IC: 7076A-ICGS000
FCC ID: QVBGS050 IC: 7076A-ICGS050
FCC ID: QVBGS075 IC: 7076A-ICG075
RF Exposure Warning:
This product complies with FCC/IC radiation exposure limits set forth for an uncontrolled
environment. To comply with RF exposure requirements, the unit must be installed and op-
erated with 20 cm (8 in.) or more between the product and your body. This product may not
be collocated or operated in conjunction with any other antenna or transmitter.
This device has been designed to operate with the antennas listed below, and having a
maximum gain of 0.5 dBi. Antennas not included in this list or having a gain greater than 0.5
dBi are strictly prohibited for use with this device. The required antenna impedance is 50
ohms.
To reduce potential radio interference to other users, the antenna type and its gain should
be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that
permitted for successful communication.
To Next Page
Loading...
Need help?
General
