Piccolo 44 from 82
www.lt-light.com
*Note 2: For Bank keys, this time, will be active if only bank keys are pressed (and in the same
category, dim, pos, etc). Pressing any other key, this last inserted time is lost.
FADE TIME FOR TEST & HOME
These edition functions, also, have been improved to allow to you a temporized function. Now it’s
possible to do a HOME, a TEST or a FLIP movement using a fade time in live.
Commands block for [TEST]:
For next commands block, {item} is the selection for [TEST], this selection can be generic
[CHANNEL][nº], [FIXTURE][nº], [GROUP][nº], [CUE][nº]
From Editor
(Examples for CUE 1)
{item}[TEST][TEST]..
[CUE][1][TEST]
Selected channel/fixture/group/cue fades into editor with the
Editor Time.
[EDT+][#]{item}[TEST][TEST]..
{item} [EDT+][#] [TEST][TEST]..
[EDT+][3][CUE][1][TEST]
There are 2 commands, entering time after or before that
{item}
Selected channel/fixture/group/cue fades into editor with #
seconds (# from 0.1 to 999.9 sec; 3 sec. in example).
*Note: This time, will be active for the consecutives [TEST]. Pressing any other key, this last
inserted time is lost.
Commands block for [HOME]:
For next commands block, {fixtures} is the selection, one or several fixtures, with all parameters or
only the selected: [FIXTURE][nº], [FIXTURE][nº][POS], [FIXTURE][nº][PARAM][nº], etc.
From editor
(Example for FIXTURE 1)
{fixtures}[HOME]
[FIXTURE][1][HOME]
Selected fixtures/parameters are edited with their HOME values,
suddenly, with no-fade.
[EDT+][#]{fixtures} [HOME]
{fixtures} EDT+][#] [HOME]
[EDT+][3]
[FIXTURE][1][HOME]
There are 2 commands, entering time after or before that {fixture}
Selected fixtures/parameters are edited with their HOME values,
fading in # seconds (#, from 0.1 to 999.9 sec).
*Nota: Only parameters set as “fade” are affected for these times.
[WHEEL]
Function of help to the edition from the encoders. This function allows you:
Search a parameter value from the encoder in temporal blind mode, and to pass it to “live” mode
immediately when the searching has ended. In example, search the desired color in the color_wheel
of the fixture 1:
[FIXTURE][1][WHEEL] Encoder [WHEEL], release the pressed key to set the encoder
value in the scene.
Copy the parameter value of the first fixture of the selection over the rest of the fixtures of the same
To Next Page
Loading...
