Lucent Technologies -48V CPS4000/CPS4000 PLUS Cabinet Power System
Issue 13 December 2000 Installation and Testing 5 - 39
Installing an Additional Battery String
Adding To An
Existing Battery
Module or
Working -48V CPS
Plant
To install an additional battery string in an existing -48V battery module
or to add an additional battery string to a working -48V CPS plant, refer
to the appropriate battery product manual.
Installing in New
Plants
Note: Lucent Technologies recommends using an authorized service
representative to install and connect batteries to a new or existing power
plant due to the exposure to hazardous voltages.
For installation in new plants, follow the procedure below:
Installing in New Plants
Step Action
1
Disconnect one battery from each battery string.
2
Verify that all power units are in Standby.
3
Install circuit breakers or fuses.
4
Reconnect the batteries.
5
Turn the power unit(s) On.
To Next Page
Loading...
