Lucent Technologies -48V CPS4000/CPS4000 PLUS Cabinet Power System
6 - 4 Remote Access and Control Issue 13 December 2000
Port Settings
Introduction This section describes the communication port settings for the internal
modem, external modem, RS-232 terminal, and RS-485 terminal ports.
Internal and
External Modem
The control unit communicates with the internal modem and an external
modem at the same communication settings. These settings are as
follows:
Baud rate: 2400
Data bits: 8
Stop bits: 1
Parity: None
RS-232 and
RS-485 Terminal
Interfaces
The control unit communicates over the RS-232 and RS-485 terminal
interfaces using the following settings:
Baud rate: 9600 default, auto baud from 1200 to 19200
Data bits: 8
Stop bits: 1
Parity: None
To Next Page
Loading...
