Lucent Technologies -48V CPS4000/CPS4000 PLUS Cabinet Power System
Issue 13 December 2000 Remote Access and Control 6 - 5
Logging In to the System
Procedure This section describes how to log into the system.
Obtaining an “Enter Password” Prompt
Step Action
1
• From a modem: Dial into the control unit and wait for the
modem to connect. After the modem connects, you will
be presented with the log-in prompt. If you do not see the
log-in prompt after the modem connects, you may have to
press the ENTER key at least twice in order to obtain the
prompt.
• From a terminal connected to the RS-232 or RS-485 port:
Press ENTER at least twice until you are presented with
the log-in prompt. The number of ENTER key strokes
required will depend on the baud rate at which you are
trying to connect. The control unit will adjust its baud rate
automatically until it recognizes the carriage return
character (ASCII 13) sent by pressing ENTER.
2
At the ENTER PASSWORD prompt, type the user or
super-user password. The default password for each level of
security is listed below.
lineage default user password
(The “user” may view any measurement, configuration, or
control parameter.)
super-user default super-user password
(The “super-user” may view any measurement,
configuration, or control parameter, and, in addition, can set
configuration and control parameters, as well as change
system passwords.)
Note: After receiving the correct password, the control unit will
respond with one of the command line prompts listed below.
* user command line prompt
** super-user command line prompt
When these prompts appear the control unit is ready to accept
commands. If the port is idle, no characters received or sent, for 15
minutes then the session will terminated.
To Next Page
Loading...
