Lucent Technologies DDM-2000 OC-12 User Manual

363-206-295
Technical Specifications
Issue 1 December 1997 10-29
CPro-2000 Graphical User Interface and
Provisioning Tool 10
The CPro-2000 Graphical User Interface (GUI) and Provisioning Tool is a
Microsoft
*
Windows based user interface that can optionally be used with the
DDM-2000 OC-12 Multiplexer. The tool simplifies and mechanizes administration,
maintenance, and provisioning operations. CPro-2000 supports DDM-2000 OC-3
Multiplexers, DDM-2000 OC-12 Multiplexers, and FT-2000 OC-48 Lightwave
Systems. A minimum platform configuration is:
■ 486 SX IBM
†
compatible desktop or laptop PC
■ Disk drive — one 1.44 Megabyte (3.5 inch)
■ Hard disk with at least 40 Megabytes of available space
■ 8 Megabyte RAM
■ MS-DOS operating system version 5.0 or later
■ Windows version 3.1, Windows NT, or Windows 95
■ Serial port (EIA-232-D) — configured as COM1 or COM2
■ Mouse
■ VGA color monitor.
CPro-2000 has been tested with AT&T, NCR , IBM , NEC
‡
, and Gateway -2000
§
personal computers. For more information, see 365-576-130, CPro-2000 User
Manual, Release 7.0. See Section 10, "Technical Specifications," for PC
requirements to use the tool.
User Panel 10
The user panel contains red LEDs for CR and MJ alarms, yellow LEDs for MN and
PMN alarms, and for abnormal (ABN) and near-end activity (NE-ACTY) status.
A green PWR ON LED is lighted when the shelf is receiving −48 V power. A green
ACO LED is lighted when the ACO function is active.
The FE SEL test, ACO/TEST, and UPD/INIT push-buttons are provided to control
system operation.
* Microsoft is a registered trademark and Windows is a trademark of Microsoft Corporation.
† IBM is a registered trademark of International Business Machines Corporation.
‡ NEC is a registered trademark of NEC Corporation.
§ Gateway 2000 is a trademark of Gateway 2000, Inc.

Lucent Technologies DDM-2000 OC-12 Specifications

General

Brand	Lucent Technologies
Model	DDM-2000 OC-12
Category	Multiplexer
Language	English