Lucent Technologies DDM-2000 OC-12 User Manual

INIT-SYS 7of6Page INIT-SYS
selectionCO/RT
DCConsettingsUserSide/NetworkSide
enable/disablechannelDCC
enable/disableLANIAO
commandtheWhen init-sys:sysctl confirmationfollowingtheentered,is
displayed:bewillmessage
!NOITUAC*/
ehtnosretemarapLLAteslliwdnammocsihtfonoitucexE
.seulavtluafedlanigiroriehtotrellortnoc
.secafretnisnoitarepos’metsyssihttpursidyamsihT
gnitucexeerofeblaunaMecivreS/resU0002-MDDehtotrefeR
.dnammocsiht
otENehtsesuacdnammocsiht,detucexenehW!noituaC
follaesarelliwnoitcasihT.margorpehttratser
,elifyrotsihehtdnaatadgnirotinomecnamrofrepeht
dnerafehthtiwemitdnaetadehtezilaitinierdna
.metsys
!NOITUACEMERTXEhtiwdeecorP
retemarapesehthtiwdnammocsys-tiniehtdetcelesevahuoY :s
/*ltcsys=sserddA
=)tiuqoteteLED/lecNACron/y(?etucexE
NOTE:
Executing init-sys:sysctl thewithrespondtosystemthecausemay
message:following values.defaulttosetParameters This
beenhasorfailedhasslotspecifiedainpackcircuitthethatmeans
beenhaveslotthatwithassociatedportsforparameterstheandremoved,
values.defaulttheirtoset
11-80 1997December1Issue OC-12DDM-2000

Lucent Technologies DDM-2000 OC-12 Specifications

General

Brand	Lucent Technologies
Model	DDM-2000 OC-12
Category	Multiplexer
Language	English